Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Open WAP200 Configuraton

I would like to know if it is possible to set up a WAP200 so people are not prompted to authenticate? I am new to this and would like to know if anyone could assist.

thank you

1 REPLY
Bronze

Open WAP200 Configuraton

Dear Martin.

Thank you for reaching the Small Business Support Community.

Even though the wireless security authentication is the recommended practice, you can disable the "Security Mode" from the Wireless>Wireless Security tab.  Just in case below is a link to the WAP200 admin guide as a reference;

http://www.cisco.com/en/US/docs/wireless/access_point/csbap/wap200/administration/guide/WAP200_V10_UG_Rev_B_web.pdf

I hope this is what you were looking for and please do not hesitate to reach me back if there is any further assistance I may help you with.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

Jeffrey Rodriguez S. .:|:.:|:. Cisco Customer Support Engineer *Please rate the Post so other will know when an answer has been found.
924
Views
0
Helpful
1
Replies