I have a wap200 and would like to set it to an open network where other people who access it aren't required to enter a username and password? I'm new at this and haven't been able to see how to set that part up and would like to see if anyone could assist?
Thank you for reaching the Small Business Support Community.
Even though the wireless security authentication is the recommended practice, you can disable the "Security Mode" from the Wireless>Wireless Security tab. Just in case below is a link to the WAP200 admin guide as a reference;
With the latest release of firmware for the WAP 561, 551, 371, 351 a new
feature was added that would allow customers to upgrade the firmware for
their clustered access points from the main access point.The basic steps
to accomplish this is:1) Download th...
Special thanks to Alex McDonald for sharing his favorite tip:My favorite
tip is the ‘write default’ command on autonomous wireless access points,
it simplifies manual conversion of a WAP with a static ip address to a
LAP with a DHCP address.This saved a l...