Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Setting channels with single point setup

Hello,

I have 3 WAP371 access points set up with singe point setup. I would like to assign the channels manually. Is this even possible? When I change the channel in the radio setup, the channel for all the access points changes.

There is a channel configuration page under the single point setup, but I find this very confusing to say the least. There is a "start/stop" button, which seems to start or stop a scanning process. The channels are then automatically assigned based on what the systeem deems is best, but I don't see a way to set the channels manually?

  • Small Business Wireless
3 REPLIES

Go to Channel Management and

Go to Channel Management and either click 'stop' or check the box 'Locked' to prevent the channel from changing.

Viewing Channel Assignments and Setting Locks
When channel management is enabled, the page shows the Current Channel Assignations table

and the Proposed Channel Assignments table

Please find the below link which will be helpful for you .

http://www.manualslib.com/manual/839621/Cisco-Wap371.html?page=156#manual

Thanks

Sam

New Member

Thank you Sam. I saw that in

Thank you Sam. I saw that in the manual, but that's the automatic assignment. You can lock the channels, but I want to be able to assign channels manually. Say I want to set access point 1 to channel 6. If I use the automatic mode I will have to wait until this channel automatically gets assigned to access point 1, if this ever happens at all...

New Member

Cisco WAP121 and WAP321

Cisco WAP121 and WAP321 devices support Single Point Setup. This simple means that they allow you to administer and control wireless services across multiple devices - no more messing about, wasting time, configuring access points individually. You use Single Point Setup to create a single group, or cluster, of wireless devices. After the WAP devices are clustered, you can view, Java deploy, configure, and secure the wireless network as a single entity. After a wireless cluster is created, Single Point Setup also facilitates channel planning across your wireless services to reduce radio interference and maximize bandwidth on the wireless network.

37
Views
0
Helpful
3
Replies