Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Swaping between two SSID is very slow , client face connectivity loss ( using WLC 2504)

Hi Guyz,

 

I am using WLC 2504 (Sysinfo given below), I created a new SSID on different VLAN, but when i used to connect to it while using previous SSID. Moving between two SSID is very slow. I have to disconnect my wifi then wait for 5 mint and then able to change to other SSID.

SSID                 VLAN

Test1                VLAN10 10.10.10.0/24

Test2                VLAN20 10.10.20.0/24

 

can anyone help me to sort out this issue

 

 

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 7.5.102.0
Bootloader Version............................... 1.0.18
Field Recovery Image Version..................... 1.0.0
Firmware Version................................. PIC 16.0


Build Type....................................... DATA + WPS

System Name...................................... WLC
System Location..................................
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.1279

Last Reset....................................... Software reset
System Up Time................................... 13 days 10 hrs 29 mins 24 secs
System Timezone Location.........................
System Stats Realtime Interval................... 5
System Stats Normal Interval..................... 180

1 REPLY
Hall of Fame Super Gold

Upgrade the firmware of your

Upgrade the firmware of your controller to 7.6.120.0 and upgrade the bootstrap too.

 

Next, post the output to the command "sh wlan id".

30
Views
0
Helpful
1
Replies