I have the following issue: I managed to configure the Wlan radio interface of a 1811W and I am using WPA2/PSK. But even I connect to the router via wireless it seems that there is no communication between the computer and the other interfaces; also DHCP is not assigning me an IP.
I should mention that I am not a cisco expert but I like to think that I have some sort of knowledge in IP networks. Can someone enlighten me?
Here is the configuration:
service timestamps debug datetime msec
service timestamps log datetime msec
enable secret 5 $1$okVP$DM2WzthHyExQEVDHHY1
no aaa new-model
dot11 ssid IvanTurbincaN
authentication key-management wpa
wpa-psk ascii 7 096D420415135A4D
no ip dhcp use vrf connected
ip dhcp excluded-address 192.168.123.200 192.168.123.254
ip dhcp excluded-address 192.168.23.200 192.168.23.254
ip dhcp excluded-address 192.168.123.100 192.168.123.126
Article ID:5727 Configure the Single Point Setup on the WAP581 Objective
A Wireless Access Point (WAP) connects to a router and serves as a node
to the Wireless Local Area Network (WLAN). Clustering is when multiple
WAPs are joined on the same network. Th...
Article ID:5706 Upgrade the Firmware on the WAP125 Objective New
firmware releases are improvements from previous firmware versions.
Network device performance can be enhanced when an upgrade is made.
Firmware files can be downloaded through: Trivial File...
Article ID:1972 Configure Time Settings on a Wireless Access Point
Objective The system clock provides a network-synchronized time-stamping
service for software events such as message logs. Without synchronized
time, accurate correlation of log files betw...