Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using Radius for Wireless Access Control on WAP4410n

I am attempting to use Radius just for the wireless access control (remaining with WPA2-Personal as the security mode) so we are able to limit the MAC addresses able to connect.

I have configured the radius details in the "Connection Control" section, and this is the same as detailed in "Article ID: 1032 Configuration of a RADIUS Server on a Wireless WAP4410N Access Point".

The client is unable to associate (times out), and the WAP has the log entries (the MAC address is that of the client):

    Jan 23 11:09:36 kernel: [][A0:88:B4:5B:0C:88] SUBTYPE_AUTH

There is absolutely no traffic to the configured radius server when the client is attempting to connect (not even an arp request, let alone UDP to port 1812).

I have confirmed that I am able to ping the radius server from the WAP (using "Diagnostics" functionality).

I am using firmware version 2.0.7.4.

Is it possible to use Radius for wireless access control on this WAP?

Nick

Everyone's tags (3)
1 REPLY

Using Radius for Wireless Access Control on WAP4410n

Hi, My name is Eric Moyers. I am a Network Support Engineer in the Cisco Small Business Support Center. Thank you for using the Cisco Community Post Forums.

It is my understanding that from your description you are wanting to use security mode WPA2-Personal but still want to access your radius server for  MAC Address connection control.

If I have a radius server already setup, why not use it for the security mode as well?

I have not personally set this exact scenario up, but unless the WAP is using the Radius for its security, instead of WPA2 - Personal, it will not be able to use it for the Connection Control. As a test if you configure it to use Radius and post the results?

Thanks

Eric Moyers    .:|:.:|:.

Cisco Small Business US STAC Advanced Support Engineer

Wireless Subject Matter Expert

CCNA, CCNA-Wireless

866-606-1866

Mon - Fri 09:30 - 18:30 (UTC - 05:00)

*Please rate the Post so other will know when an answer has been found.

860
Views
0
Helpful
1
Replies
CreatePlease login to create content