Using WAP4410n as repeater with non Cisco brand (DLink)
Dear Support team,
I am facing this problem since a few months now. As per my initial conversation before purchasing WAP440n device. I called Cisco and they told me that it will work with non Cisco router. After that I bought it. Now when I try to configure WAP410n as repeater it don't work.
I would appreciate if you please guide us step by step so tat I make my network operation. There is no such direct and specific guide to this as per my knowledge.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...