I am a newbie technical support. Currently, I encountered a issue about WAP321 that will occasionally disconnecting all the clients(about 7 clients only) in one shot and cannot connect back at all. However, after login to the Web Gui and reboot the WAP321. It is able to connect again.
I had upgrade the firmware to 18.104.22.168 but the problem still exists. The AP is using only WPA2-Personal.
The environment of the AP is like this:
Internet->Watchguard Firewall (with AP too but different SSID with the WAP321, flat vlan) ->switches and WAP321
Is that any misconfiguration of the AP or the network environment cause this issue?
Another problem is the time of the AP cannot be fixed. I had tried either set the time using NTP (port 123 is opened in firewall) or manually input but it will revert back to 1999 after reboot.
Get to Know the WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN
The WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE Local Area Network (LAN) delivers secure and reliable wireless connectivity. It ...
Product Specifications of the WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN
The WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN delivers secure and reliable wireless connectivity. It allows you t...
Configure the Single Point Setup on the WAP581
A Wireless Access Point (WAP) connects to a router and serves as a node to the Wireless Local Area Network (WLAN). Clustering is when multiple WAPs are joined on the same netwo...