I have two WAP121 with latest FW and I setup the scheduler according help and documentation to disable our secondary guest network in non-office hours. The problem is that it's still always enabled. I just can't make it work. Below are my settings, do I do something wrong or is this a known issue?
Prerequisites: SNTP is configured, both WAP have the correct time Scheduler is administratively enabled
Profile: Configured one Profile for the guest network with two rules: 1. Weekdays / 9:00 - 20:00 2. Saturdays / 9:00 - 20:00 --> As I understood, that should enable access to the network assigned for Monday to Saturday between 9 and 20:00
Assignment: Assigned the above profile to the guest network (VAP1)
Problem is that during night and even on Sunday, the guest network is still shown as enabled and also is visible/accessible on the clients.
Article ID:5727 Configure the Single Point Setup on the WAP581 Objective
A Wireless Access Point (WAP) connects to a router and serves as a node
to the Wireless Local Area Network (WLAN). Clustering is when multiple
WAPs are joined on the same network. Th...
Article ID:5706 Upgrade the Firmware on the WAP125 Objective New
firmware releases are improvements from previous firmware versions.
Network device performance can be enhanced when an upgrade is made.
Firmware files can be downloaded through: Trivial File...
Article ID:1972 Configure Time Settings on a Wireless Access Point
Objective The system clock provides a network-synchronized time-stamping
service for software events such as message logs. Without synchronized
time, accurate correlation of log files betw...