WAP200 Repeater Mode with Cisco & Linksys Equipment
I am trying to connect a WAP200 to a Linksys WRT300N router in repeater mode for one of our locations. At the other location that we have i am trying to connect the WAP200 to a Cisco Aironet 1100 Series AP. Is this compatable? I have done a site survey on both locations and DHCP will not relay any info. I have the security and all other settings identical to the main AP at each location. I can not connect both WAP200s together at one location as neither one can go without wireless. Any help or information would be great. Thanks.
Article ID:5727 Configure the Single Point Setup on the WAP581 Objective
A Wireless Access Point (WAP) connects to a router and serves as a node
to the Wireless Local Area Network (WLAN). Clustering is when multiple
WAPs are joined on the same network. Th...
Article ID:5706 Upgrade the Firmware on the WAP125 Objective New
firmware releases are improvements from previous firmware versions.
Network device performance can be enhanced when an upgrade is made.
Firmware files can be downloaded through: Trivial File...
Article ID:1972 Configure Time Settings on a Wireless Access Point
Objective The system clock provides a network-synchronized time-stamping
service for software events such as message logs. Without synchronized
time, accurate correlation of log files betw...