WAP200E Comes and goes- Can Connect to AP, no Net Connection
I have a WAP200E and it seems like this is the Lemon of all APs. Its connected via PoE, mounted outside is a pretty covered area with Antenne is a good spot.
It seems like it will loos its connection to the Network, though still allow clients to Connect Wirelessly. I cannot Access it via its Ethernet Port from the LAN unless I power Cycle it. Then at some unknown time I loose connection to it again. It comes back for a while, then I lose it again.
From the Releae notes it looks like Firmware 2.0.5 is out, though the latest on the Support site is 2.0.3.
Any Tips to get this guy working again? I love the External AP, when it works I can get Signal on most of the 2 Acres. I's hate to have to put Range Extenders in all my outbuildings...
Article ID:5727 Configure the Single Point Setup on the WAP581 Objective
A Wireless Access Point (WAP) connects to a router and serves as a node
to the Wireless Local Area Network (WLAN). Clustering is when multiple
WAPs are joined on the same network. Th...
Article ID:5706 Upgrade the Firmware on the WAP125 Objective New
firmware releases are improvements from previous firmware versions.
Network device performance can be enhanced when an upgrade is made.
Firmware files can be downloaded through: Trivial File...
Article ID:1972 Configure Time Settings on a Wireless Access Point
Objective The system clock provides a network-synchronized time-stamping
service for software events such as message logs. Without synchronized
time, accurate correlation of log files betw...