I was reading through a couple of posts stating the captive portal feature on WAP321 is only supported on VLAN1 (admin VLAN); as in my installation, like in probably 99% of all, my guest VLAN where I need the captive portal for is NOT set to VLAN1 and will never be that.
I'm wondering when Cisco will finally fix this issue and whether anybody has information on that. I could not find an entry in the release notes.
Article ID:5727 Configure the Single Point Setup on the WAP581 Objective
A Wireless Access Point (WAP) connects to a router and serves as a node
to the Wireless Local Area Network (WLAN). Clustering is when multiple
WAPs are joined on the same network. Th...
Article ID:5706 Upgrade the Firmware on the WAP125 Objective New
firmware releases are improvements from previous firmware versions.
Network device performance can be enhanced when an upgrade is made.
Firmware files can be downloaded through: Trivial File...
Article ID:1972 Configure Time Settings on a Wireless Access Point
Objective The system clock provides a network-synchronized time-stamping
service for software events such as message logs. Without synchronized
time, accurate correlation of log files betw...