Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

WAP321 - How can I distribute bandwidth to different SSIDs?

I just purchased the WAP321 and am overwhelmed by the amount of controls in the admin interface.

I had a WAP4410N (which I returned to Cisco), which had the option of allowing me to distribute my bandwidth to different SSIDs on the same access point.

I am not able to find the options in the WAP321. Has anyone done this yet and could you please share how you went about it?

Thanks!

Jack

Singapore

  • Small Business Wireless
Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: WAP321 - How can I distribute bandwidth to different SSIDs?

Hi Jack,

This WAP seems to extend the options available to you compared to the older WAP4410N.

You can add people to different SSID if you want.  You then have to option to limit the virtual AP, check out the screen capture below;

You can see that I circled the help option, select this option if you want to understand this page in greater detail.

regards Dave

3 REPLIES

Re: WAP321 - How can I distribute bandwidth to different SSIDs?

Hi Jack,

This WAP seems to extend the options available to you compared to the older WAP4410N.

You can add people to different SSID if you want.  You then have to option to limit the virtual AP, check out the screen capture below;

You can see that I circled the help option, select this option if you want to understand this page in greater detail.

regards Dave

New Member

WAP321 - How can I distribute bandwidth to different SSIDs?

Hi David,

Thanks for the information. Will go check on this page.

Much appreciated.

Cheers,

Jack

New Member

WAP321 - How can I distribute bandwidth to different SSIDs?

Hi David,

I must be blind. It was just there, but I did not see it! Thank you for pointing me in the right direction!

Cheers,

Jack

1730
Views
0
Helpful
3
Replies