cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1488
Views
0
Helpful
1
Replies

WAP371 after upgrade to 1.3.0.6 fails

jara
Level 1
Level 1

I have 4 WAP371 in one "Single Point Setup" Cluster.

After "Cluster Firmware Upgrade" two of APs will not alive - I see APs have a connection to switch, power is up but did not respond on any IP.

In dump I see only packets

IP6 :: > ff02::1: HBH ICMP6, multicast listener querymax resp delay: 1000 addr: ::, length 24

IP 0.0.0.0 > 224.0.0.1: igmp query v2

every two minutes

 

What we can do for recovery of firmware?

 

1 Accepted Solution

Accepted Solutions

jara
Level 1
Level 1

we succeded with factory default (not only touching reset button but combination of reset button and power off/on) and we were able to reconfigure the AP with joining to cluster.

All is working now again

 

View solution in original post

1 Reply 1

jara
Level 1
Level 1

we succeded with factory default (not only touching reset button but combination of reset button and power off/on) and we were able to reconfigure the AP with joining to cluster.

All is working now again

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: