I have two WAP4410's that dont work correctly like other peoples on this site, one unit has been RMA and a replacement has the exact same issues. im currently going through a tac case with their support engineers but im looking at my options just in case the engineers cant resolve the issue.
I had great hopes for the small business range i have 6 of their SG300-28P's which had the mac address issue (causing them to lock up. this is now resolved but was embarrassing that the switch would have to also be rebooted every 30 days) as well as two of these Access Points and im starting to think i wont be recommending the small business range to clients and colleagues.
i have seen that cisco have now just released the WAP321 has anyone got one of these units yet (i know they are pretty new) and secondly do they actually work as im starting to think the WAP4410 does not. i would like some advice from any users who have these new units in the event that the WAP4410's issues cant be resolved and i have to upgrade to a different unit as the downtime is killing our network.
well i got my case promoted to the second line support team for them to give me a firmware beta that will be the next release which has still not fixed the wireless access point. im still awaiting a response from the second line support team to see what if anything can be done next
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...