Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAP4410n can not access Web admin after upgrade

Hello,

I have two WAP44's,  both with the well know drop connection problem.  I upgraded the firmware on one and now I can not access the admin webpage.

I read somewhere(information is so buried on this website it's a crime) the the new firmware uses DHCP as a default.  I added the 802.11 side's MAC to the DHCP server before the upgrade so I could talk to the AP after the upgrade.  After the AP rebooted I was able to ping the AP over copper but I can not open a webpage.

Did the default home page change names?

We still have connectivity across the bridge.  I'm using IE7.

What gives?

Thanks in advance

-Wade

1 ACCEPTED SOLUTION

Accepted Solutions

Re: WAP4410n can not access Web admin after upgrade

Reset the device after the Firmware is upgraded and try again. To reset press the Reset button for approximately 10

seconds and try again with the default IP address of the AP.

3 REPLIES

Re: WAP4410n can not access Web admin after upgrade

Reset the device after the Firmware is upgraded and try again. To reset press the Reset button for approximately 10

seconds and try again with the default IP address of the AP.

New Member

Re: WAP4410n can not access Web admin after upgrade

Thanks for the reply,  I'll try that.  But like I wrote....the new firmware no longer has a default IP and instead uses DHCP,  or did I miss read that from some long lost PDF file off Ciso's website??

I'll give it a try tomorrow.

Thanks again

-Wade

Re: WAP4410n can not access Web admin after upgrade

If the device uses DHCP , then use the DHCP address to access the GUI.

1227
Views
0
Helpful
3
Replies