Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAP4410N Completely unreliable

I have been banging my head against the wall for a week now, I have been unable to get this device to work reliably. It will work for minutes to hours but then stop passing traffic for some or all clients, and getting a DHCP address while connected will be impossible. I have already updated to the latest firmware listed. Any ideas would be greatly appreciated! I am running the device in AP mode with two SSID's one with WPA2 enterprise, and the other WPA2 personal. I am running in Mixed N mode and have both N clients and G clients, both have been unreliable.

Everyone's tags (1)
4 REPLIES
New Member

Re: WAP4410N Completely unreliable

I believe may be multiple reasons why this is happening, the most accurate response about this scenario  is that you should contact us here at 1866-606-1866, it seems to be like you have compatibility issues between your laptops and the encryption methods.

Please again give a call when you get a chance, this phone only service Unite States and Canada.

New Member

Re: WAP4410N Completely unreliable

Thank you, I will give them a call on monday.

New Member

Re: WAP4410N Completely unreliable

I did not have a chance to call but I wanted to relay to you that I tracked the problem down to a CISCO switch that had port security turned on.

New Member

Re: WAP4410N Completely unreliable

Since this issue is related to the switch I am going to mark this as resolved.

1401
Views
0
Helpful
4
Replies