We have AP - A, B and C all configured static and outside of our DHCP scope
A - 104.240
B - 104.241
C - 104.242
WAP A is setup to allow the MAC's of A and B to repeat its signal
The issue starts about 1-2 minutes after I set B and C to client/repeater and select A in site survey then save the settings. Obviously its weird that only our 2003 servers are getting this error
The system detected an address conflict for IP address 192.168.105.201 with the system having network hardware address *MAC ADDRESS OF ROUTER A*. Network operations on this system may be disrupted as a result.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...