Router -> Cisco Access Point WAP4410N (default AP mode) -> 1st repeater -> 2nd repeater
I can connect through router (used as DHCP) and Cisco AP. It seems that from Cisco AP signal is not passed further the right way. The problem occurs when connecting via 1st or 2nd repeater. Connectivity is limited with no internet access. If I use static IP (for example 192.168.1.11) everything works.
Settings of Cisco AP: IP: 192.168.1.245 Gateway: 192.168.1.1 DNS: 192.168.1.1
With the latest release of firmware for the WAP 561, 551, 371, 351 a new
feature was added that would allow customers to upgrade the firmware for
their clustered access points from the main access point.The basic steps
to accomplish this is:1) Download th...
Special thanks to Alex McDonald for sharing his favorite tip:My favorite
tip is the ‘write default’ command on autonomous wireless access points,
it simplifies manual conversion of a WAP with a static ip address to a
LAP with a DHCP address.This saved a l...