Hello, I have a client who has three WAP4410N Firmware V 1.0.12 and Hardware Rev.12 all connected to an RVS4000 as a gateway, when using wireless clients to access wirelessly the management interface of all three only two open, the third one gets a page load error, when he closes one of the interfaces that did open and tries to open the one that didn't it works and the one that worked...does not for example .5 .6 .7 if .5 opens and .6 works .7 does not, if he shuts off .5 and tries to access .7 it works but .5 will not open. He is able to ping the device that won't open and able to go out to the internet, just no interface, anyone know if the wireless interface access is only two at a time? could this be a bug? he says the WAP4400N does allow more than two open at a time. Thanks in advance.
I've posed this situation to the WAP4410N product manager just now. He stated he will look into it and let me know what he finds out. I'll post his response as soon as I get it back from him. He did state this sounds like unusual behavior, but would need to verify that. I'll keep you posted!
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...