cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
617
Views
0
Helpful
1
Replies

WAP4410N not responding

Noor_khaldi
Level 1
Level 1

I have two WAP4410N access points, each running with the following information:

- Wireless Network Mode: N-Only
- Wireless Channel: Auto
- Security Mode: WPA2-Personal (AES)
- PID VID: WAP4410N-E V02
- Software Version: 2.0.7.4

The access points stops responding on daily bases where no one is able to connect to them, we're able to connect to the management page of the access points, but the logs there are showing no errors. 

The only solution for the access points to work it so disconnect them from power and reconnecting them again.

Help please? how do I find out whats really going on with the access points that causes them to lock up like this? and is there a solution for this?

1 Reply 1

Ismael Arroyo
Level 1
Level 1

 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: