WAP4410N problesm whit IPSec VPN Tmobile UMA service
HI, this is my first post. I have reading that WAP4410N it's not very popular, we bought 4 units to usead in our office. In our building we have really bad Tmobile Coverage so we decide to take advantage of the UMA Service. Routing Calls trough Internet but we only have problems.
I couldn got the phones to use this UMA service, basically a VPN (IPSec) so I upgrade to the latest firmware and now I can establish this connection but unable to use the calling feture drop calls and time out errors.
I double check it my Routers and to discard the router I change the wap4410N fo a WAP54G and work just fine, blackberry get calls and place calls using the UAM tmobile service.
So, is this enought to say that my new WAP4410N it's the problem?
Does any one know how to work around the IPsec issue?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...