We have a WAP4410N wireless ap configured for WPA2-Enterprise. Initially everything works. Issue the user the proper certificate and they sign on correctly but once they disconnect and try to reconnect later it get stuck on "Validating Identity". The request never get to RADIUS server (no success/failure log entry, no radius traffic). Once I reboot the access point everyone can connect again but as soon as they disconnect the problem happen again.
We testing other security settings (WPA-ENT, RADIUS(!), WPA2-Personal etc) and no problems. With older firmware have the same issue.
Operating system: XP SP3, RADIUS server: IAS. Firmware: 184.108.40.206
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...