Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WAP561 and CDP Protocol and Telnet.

Hi all; I installed 06 Cisco WAP561, are working normally, but I have noticed that the CDP protocol does not recognize the WAP, when from a switch catalyst 3750, I run the "sh cdp nei" command, the command output does not display the port where this WAP installed. Similarly access does not work through TELNET. 
 
Waiting for your news.

Regards.

Fernando

125
Views
0
Helpful
0
Replies
CreatePlease to create content