Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAP561 Enabling Telnet and SSH

Hi,

We have two WAP561 devices and they have shipped with firmware 1.0.3.4. In the release notes of this firmware, there is an open caveat with the reference number CSCty22825, stating that telnet and ssh is disabled in GUI and SNMP. In the release notes of further releases, such as 1.1.0.4, this caveat is no longer present. We have upgraded our devices to 1.1.0.4, yet telnet and ssh section is still not present in the GUI.

Is there a way to enable ssh on these devices? In the administration guide, there should be a section called "Telnet and SSH" but, it is not present in the GUI. We have also checked with the emulators with different firmwares. Still no telnet and ssh section.

Your help is very much appreciated.

Thanks,

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Hello,Those options were

Hello,

Those options were available in a very old firmware (the first release) which is no longer present on the cisco.com site and unfortunately I don't have. For security reasons those options were removed from the newer firmwares available.

I hope that the information provided was useful.

If you have any further questions do not hesitate to get in touch with me.

Best Regards,

4 REPLIES
New Member

Hello,Those options were

Hello,

Those options were available in a very old firmware (the first release) which is no longer present on the cisco.com site and unfortunately I don't have. For security reasons those options were removed from the newer firmwares available.

I hope that the information provided was useful.

If you have any further questions do not hesitate to get in touch with me.

Best Regards,

New Member

So, there is no way to enable

So, there is no way to enable ssh. Am I correct?

New Member

Yes you are correct.

Yes you are correct. Unfortunately there is no way to enable those features on this AP.

Best Regards,

New Member

Thanks.

Thanks.

397
Views
0
Helpful
4
Replies
CreatePlease login to create content