Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAP561 spontaneously jumping channels

Hello Cisco

I have a brand new WAP561 out of the box, i installed the 1.1.0.4 firmware and set it up using only one radio set to a fixed channel (104).

After a while my clients loose connection to the network.

I then looked at the setup again, i seems that the AP spontaneously changed channel.

This causes clients to disconnect and only a connection reset on the client gets it back on the network.

 

Why does this happen?

How do i prevent it from happening in the future?

77
Views
0
Helpful
0
Replies
CreatePlease login to create content