Why won't the page update when I enable the radios on my AIR - LAP1131AG?
I'm trying to configure this AP. Every time I change something I get a pop-up box saying that it will be updated. For some reason, when I try to enable the radios, I get no box and, although the Apply button clicks, it doesn't do anything.
Though seriously, UI has never been a problem with Cisco, Through I do recommend doing this
1. Use IE(internet exp) considering your AP is quite old, EoS level old, you probably should and also lower down the sec. settings on the browser as well, and disable pop-up blocker
2. technical causes: A. Your configuration is still lacking/some errors, make sure to verify, most config errors are missing VLANs, guest-mode not enabled or if MBSSID, then well, MBSSID mode, bridge-group ID for MBSSID
B. You power supply device (PoE or power-supply) is not supplying enought power, check through UI(only way as well is throughUI)
AT: Software Tab CLICK: System Configuration SEE: System Power Settings
Get to Know the WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN
The WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE Local Area Network (LAN) delivers secure and reliable wireless connectivity. It ...
Product Specifications of the WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN
The WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN delivers secure and reliable wireless connectivity. It allows you t...
Configure the Single Point Setup on the WAP581
A Wireless Access Point (WAP) connects to a router and serves as a node to the Wireless Local Area Network (WLAN). Clustering is when multiple WAPs are joined on the same netwo...