i have this very weird configuration to which i should add a wireless bridge to create a backup:
cisco_sw_0 is connected with cisco_sw_1 with two ethernet connections.
now they are using a single network.
i think that i should start by slit the network into two separated networks, turn the two ethernet connections into ppp links and use a thirdh port/sw to connect two ap in bridge mode using ospf to manage the traffic throught the two different locations.
is there anyone with some personal experience who can write me two lines just as a scratch for this project?
the switches are cisco.
the ap are linksys.
thank you in advance. any help will be appreciated.
Article ID:5727 Configure the Single Point Setup on the WAP581 Objective
A Wireless Access Point (WAP) connects to a router and serves as a node
to the Wireless Local Area Network (WLAN). Clustering is when multiple
WAPs are joined on the same network. Th...
Article ID:5706 Upgrade the Firmware on the WAP125 Objective New
firmware releases are improvements from previous firmware versions.
Network device performance can be enhanced when an upgrade is made.
Firmware files can be downloaded through: Trivial File...
Article ID:1972 Configure Time Settings on a Wireless Access Point
Objective The system clock provides a network-synchronized time-stamping
service for software events such as message logs. Without synchronized
time, accurate correlation of log files betw...