My question is with the 521g(lighweight) acess point using the 526 wireless express mobility controller do you still need to run cat5 to the wireless access point? or is there just a power injector used and the wireless is controlled through the controller to each access point?
Each AP521 in LWAPP mode should be connected to the UC520 / UC540 to one of the POE switch ports (or a POE Switch switch port connected to the UC500 expansion port) with Smart Port Role set to AP. The WLC526 connects the same way with the same switch port role.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...