Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

WLAN 4400 - Trunking issue

Hi all,

We are having an issue setting up a truck port for the 4400 to our 2950 swithes.

The setup will work fine without vlan tagging. The WLAN controller can ping the switch and our network.

When I configure trunking on the switch, the connection drops.

I have configured the Gi 0/2 port with the below commands

interface gi 0/2


Switchport trunk allowed vlan 1-10

switchport mode trunk

No shut

Modifying the WLAN 4400 I set the management interface tagged for vlan 2.

This breaks the connections between the WLAN controller and the switch.

Can you advise where I may be going wrong and how to rectify.

216
Views
0
Helpful
0
Replies
CreatePlease to create content