I'm using a Cisco WRT600N (1.01.36 build 4) and cannot figure out how to keep the DHCP server disabled. There's another DHCP server on my network, and the WRT600n messes things up all the time. Disabling the feature on the WRT600n, then rebooting keeps it off for at most a day or so, but then it re-enables itself while the GUI shows it as disabled.
This is unexpected behavior and should not happen with a mature firmware release.
If this had been on of our devices, I would first suggest making sure that the FW is up to date. Then doing a factory reset and manually reconfiguring the device. If that does not work, I would call the Consumer Support line 1-800-326-7114
Configure Client QoS MAC Class Map on the WAP125 or WAP581
The Quality of Service (QoS) feature on the WAP125 or WAP581 access points contain Differentiated Services (DiffServ) support that allows you to classify and man...
Configure Packet Capture on a WAP125 or WAP581 Access Point
The Packet Capture feature enables capturing and storing packets received and transmitted by the Wireless Access Point (WAP). The captured packets can then be anal...
Configuring WPA-PSK Complexity on the WAP131, WAP351, and WAP371
When a VAP (Virtual Access Point) is configured, there are several options available for securely authenticating clients. If WPA Personal is selected (also kn...