cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1166
Views
0
Helpful
2
Replies

WRVS4400N Wireless Signal Inconsistency

mavbritton
Level 1
Level 1

Hi

I have a WRVS4400N and it basically disconnects everything connected to it on a daily basis and the only way of re-connecting to it, is by switching it off and back on again at the mains.

It is sat behind an orange livebox which acts as the modem; so it's sole purpose it to protect everything connected to it wirelessly and via ethernet.

Connected to the WRVS

2 * laptops, connnected via bg class only

1 * MFC Printer (wired)

1 * Iomega NAS (wired)

Once the connection fails and the notification pops up on the laptops, the 'wireless' led goes out on the WRVS.  I have tried to connect a spare LAN to one of the laptops and it will not re-connect this way either.

This has been going on for around 6 months now.  Any ideas?

Kind regards

Mark

2 Replies 2

Steven DiStefano
VIP Alumni
VIP Alumni

Hi Mark,

Can you check to see what firmware are you running an dmake sure you have the latest.

Many of the small business FWs can be linked from this page:

http://www.cisco.com/cisco/psn/web/solutions/small_business/products/firmware.html

here are the release notes for both V1 and V2 HW models

Cisco WRVS4400N Wireless-N Gigabit Security Router - VPN V1.0 & V1.1

Cisco WRVS4400N Wireless-N Gigabit Security Router - VPN V2.0

Hi Steve

Sorry for the late reply, I've recently moved and it's taken two weeks for them to move the broadband over.

I have a 1.1 with firmware .13 running.

Oh and i've had to reset twice already today!

Kind regards

Mark

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: