I would like to know how to configure an Active Passive failover solution using BGP + HSRP(with ip sla to track line up/down) in 2x Cisco CPE. For example the IP assignment as below: Primary Router:- WAN IP: 10.10.10.2/30; GW: 10.10.10.1/30 LAN IP(Primary): 172.16.1.1/24 LAN IP(Secondary): 22.214.171.124/24 HSRP Virtual IP: 172.16.1.3
Backup Router:- WAN IP: 10.10.10.6/30; GW: 10.10.10.5/30 LAN IP(Primary): 172.16.1.2/24 LAN IP(Secondary): 126.96.36.199/24 HSRP Virtual IP: 172.16.1.3
BGP info: AS No: 12345 Remote-AS: 67890 Password: abcde
There will be an unmanaged switch connect to these 2 routers LAN interface and my PC will connect to this switch to perform failover test.
Appreciate if anyone can share his/her knowledge and guide me on this. Let me know if the details above is insufficient.
I know the basics for Cisco routers and switches but what I want to know is, if I set up VTP on a switch, is there a way to send it through routers to other switches? This will probably end up more hassle than gain, but it's interesting and cool to p...