Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

[Cisco FAQ] - Why does the DCM still show a transport stream on a Gbe input although it is not present anymore?

How do I change this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Why does the DCM still show a transport stream on a Gbe input al

This usually means that the input transport stream still has some settings o Check the alarm status of the input TS. Here you will see the reason why the TS still exists o Check that all input TS settings are set to the “default” value : to do this double click on the Gbe input TS and check all tabs : Services, TS FEC, TS Settings, TS Loss, TS Backup and make sure “default” settings are applied everywhere o Check that nothing is groomed anymore from the TS. From V5.1 onwards it is possible to right-click an input service and do a “Find Destinations” on it, … When all settings are reset to “default” values and nothing is groomed anymore from the TS, the TS should disappear completely after a maximum of 2 minutes

1 REPLY
Cisco Employee

Why does the DCM still show a transport stream on a Gbe input al

This usually means that the input transport stream still has some settings o Check the alarm status of the input TS. Here you will see the reason why the TS still exists o Check that all input TS settings are set to the “default” value : to do this double click on the Gbe input TS and check all tabs : Services, TS FEC, TS Settings, TS Loss, TS Backup and make sure “default” settings are applied everywhere o Check that nothing is groomed anymore from the TS. From V5.1 onwards it is possible to right-click an input service and do a “Find Destinations” on it, … When all settings are reset to “default” values and nothing is groomed anymore from the TS, the TS should disappear completely after a maximum of 2 minutes

364
Views
3
Helpful
1
Replies