When doing audio pass through the audio is being externally encoded. The external device is where the delay is being introduced. There is a field in the D9036 under the audio setting in the Basics tab. Go to the bottom of the page and you will see the External Delay. This is where you can increase or decrease the delay to compensate for the encoding. Your external audio encoder may give you what this delay value should be. Check with the audio encoder specs for this information.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...