I setup our D9854s for HD-SDI output with AC3. Looking at the SDI feed through a Tektronics WVR 7120, it appears it’s seeing the channels as PCM, with repeating noises. Also, my encoder does not reconize the audio at its input. We have several D9854 IRDs with this same AC3 issue.
The attached screenshot.IRD is my IRD settings and jpg 1 is a photo of the Tektronics WVR 7120. There may be something I'm setting wrong inside the IRD, your help will be greatly appreciated.
Tony, what is the Current App version, and current FPGA version of your receiver? You can find this information in the Main Menu - Versions section. You are setting the 'Digital Out Preference' to 'Compressed'. Can you try to set this to 'PCM Samples'?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...