Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is it possible to Configure DCM 9901 port as I/O?

Is it possible to Configure DCM  9901 port as I/O?

5 REPLIES
Cisco Employee

the Management ports of the

the Management ports of the DCM can not be used to stream video content, so each chassis needs at least a Gbe IO card to handle multiplex the video streams
 

New Member

How i can configure output

How i can configure output streaming ?
Do i need multicasr or i an use unicast ?

Cisco Employee

Hi Emin, Bot multicast and

Hi Emin,

 

Bot multicast and unicast can be used on the DCM output and input. You also have the possibility to use UDP or RTP.

Hope this answers your question.

New Member

Do i need configure all IGMP

Do i need configure all IGMP configuration on DCM or i can do it my routers ?
After configuring multicast ip address in my router then i can connect my DCM to this mulricast group ?
 

How i can connect unicast on DCM ,can i ckeck streming with VLC Player ?

Cisco Employee

Hi Emin, You will need to

Hi Emin,

 

You will need to configure the multicast joins on your DCM to define what sources you need.

Of course you will also need to configure your router ports to enable multicast, configure PIM ...

When using unicast, you just need to stream your feed to one of the ip ports on the Gigabit ethernet card or 10 gig card.

you can use VLC to receive a transport stream.

Remark that an online help and manual is available on each DCM device.

177
Views
0
Helpful
5
Replies
CreatePlease login to create content