Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

32-port line card B2B credits

When I setup an E-port on the first of the four ports in a quad , how can I allocate the number of B2B credits from default 12 to a higher number which are not used by the three disabled ports?

1 REPLY
New Member

Re: 32-port line card B2B credits

Hi Michal,

The receive BB_credit values depend on the module type and the port mode.

For 32-port switching modules and host-optimized ports, the default value is 12 for Fx, E, and TE modes. These values cannot be changed.

For 16-port switching modules and full rate ports, the default value is 16 for Fx mode and 255 for E or TE modes. The maximum value is 255 in all modes. This value can be changed as required.

Here is an example how to change it:

gislaved(config-if)# switchport fc

fcrxbbcredit fcrxbufsize

gislaved(config-if)# switchport fcrxbbcredit ?

<1-255> Enter receive BB_credit

default Default receive BB_credit

performance-buffers Configure performance buffers for receive BB_credit

gislaved(config-if)# switchport fcrxbbcredit 30 ?

mode Configure receive BB_credit for specific mode

Carriage Return

gislaved(config-if)# switchport fcrxbbcredit 30 mod e?

E

gislaved(config-if)# switchport fcrxbbcredit 30 mode ?

E Configure receive BB_credit for E or TE mode

Fx Configure receive BB_credit for F or FL mode

For further details, you may want to check out the following URL :

http://www.cisco.com/univercd/cc/td/doc/product/sn5000/mds9000/2_0/cliguide/part3/intf.htm#wp1142512

Thanks,

Hakan.

184
Views
0
Helpful
1
Replies
CreatePlease login to create content