During initial configuration of 9216 switch, the default user/password of admin/admin were used. I now want to change the default user password to something else. Can this be done using the command: username admin password 5 (new password) role network-admin? I want to make sure before I try changing it and cannot get back into the switch.
I would suggest to have two telnet session while changing the paswords. You change the password on one of them, even if you make a mistake you will still have connection to the sw with the other telnet session with the admin rights.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...