how can i check aggregated bandwidth we really get from the trunked ports? for example i have two 10Gbps card in trunk, i want to make sure i am getting the maximum out of those ports. How can i configure to get the maximum bandwidth and then how do i measure it? Is there switch inbuild commands or tools which i could make use for this? My scenario is those connections are going to be used for disk to disk backup solutions using NFS protocol
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...