Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

boot from SAN and number of HBAs

Hello,

I have question about numbers of vHBAs for server which boots from SAN. Should I use 2 vHBAs only for boot, and another 2 for data or I should create only 2 vHBAs in service profile and use them for all kind of traffic ? Which design is proper or wrong ?

Everyone's tags (3)
1 REPLY
VIP Red

HiBoth methods are possible.

Hi

Both methods are possible. I usually prefer to have 2 vhba's for boot (one on fabric A resp B) and 2 vhba's for data.

This would allow you to clearly separate the traffic by using separate VSAN's and/or storage subsystems.

As zoning is done per VSAN, it also gives you some protection against zoning configuration errors.

The downside is that you have double the number of fc zones, that you have to implement and maintain.

If you have only one pair of vhba's, the initiator pwwn for boot and data lun are identical, therefore you have to map this to different lun id's (lun masking / mapping on the array).

Hope that helps ?


 

30
Views
0
Helpful
1
Replies