Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bootflash is read-only

Hi! I've done some very terrible stuff: I wanted to upgrade NX-OS 4.2 to 5.0(1) on MDS 9124, copied boot images to bootflash, deleted existing ones, but when I start the upgrade I discovered that system boot images was not copied successfully. Now, I can't copy boot image again since bootflash fs is in read-only mode... This is completely my fault, I realize it, but can I do something with it?.. Is there a way to remount bootflash fs in read-write mode?

1 REPLY
New Member

Re: Bootflash is read-only

I coped with the problem: format bootflash: check-filesystem did the job

787
Views
0
Helpful
1
Replies