We currently have two MDS 9513's using code level 3.2(2c) and have several IBM BladeCenter's trunked in with the 9124 Cisco modules. The 9124's are currently at the same code level. How can I determine if we upgrade the 9513's to version 4.1(1c) if the 9124's will still work at the lower code level? I understand that it would be ideal to upgrade all to the same level at the same time but we have to go through another channel to get the BladeCenter 9124's upgraded.
Thanks for pointing me to the Release Notes. It has the information I was looking for. For me to install the the 4.1(1c) code I will need to upgrade the 9124's as well. I am also required to install an interm release per the Release Notes. Going from 3.2(2c) directly to 4.1(1c) is not supported. Looks like I'll be busy that day.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...