Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CFS and Zone Distribution NX-OS 6.2(1) MDS9500

Hello all!

Ihave a question. My SAN layout is configured of 4 switches (2 remote/2 local).

Fabric A:

Switch1   <-------  DWDM  -------- > Switch 3

Fabric B:

Switch 2 <-------  DWDM ---------> Switch 4

I made a change to the Call Home feature on switch 1, however it sent the contact infor and everything to switch 3. I am not the contact person for switches 3 & 4.

My question is this:  If I turn off CFS, will it interfere with the zoneset distribution?  I need the switches to be aware of the zones in both fabrics.

Any help is appreciated.

Regards,

Nathan

  • Storage Networking
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

CFS and Zone Distribution NX-OS 6.2(1) MDS9500

2 REPLIES
Cisco Employee

CFS and Zone Distribution NX-OS 6.2(1) MDS9500

New Member

CFS and Zone Distribution NX-OS 6.2(1) MDS9500

dakester,

Thank you for your response. That ahs definitely helped me. I disabled CFS using your suggestion.  However, when I did I saw that the callhome was still under CFS control (device manager said that CFS was still enabled).  Thus I found the distribute command under the callhome section. I executed the following commands:

conf t

calhome

no distruibute

ctrl-z

That helped me completely remove the callhome feature from CFS control. 

Thank you for putting me onto that path!

Regards,

Nathan

654
Views
0
Helpful
2
Replies
This widget could not be displayed.