Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CFS error message

I added a second switch on our fabric to use "Call-Home" and enabled CFS for Call-Home. I get the following error message, when I try and send a test, it worked fine before the second switch was added.

"callhome:warning:no callhome message sent"

Thanks.

1 REPLY
Bronze

Re: CFS error message

Once you have configured the contact information, you must enable the Call Home function. The enable command is required for the Call Home function to start operating

http://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_1_x/1_0_2a/san-os/configuration/guide/CallHome.html

176
Views
0
Helpful
1
Replies
CreatePlease to create content