I got 2 MD 9124 but I can’t figure out how to make them “talk” to each other.
If I login to switch 1 with the fabric manager I can see what’s connected to the end of switch 2 but I can’t “talk” with switch 2, also my host on switch 1 can’t talk with my san on switch 2 and it’s the same thing if I hook up to switch 2.
If I put everything in 1 switch it works fine so I’m guessing it has something to do with my trunk port between the switches.The trunk looks like it working because it’s coming up with no errors.
I’m a SAN switch rookie and I’m starting to run out of idea’s so hope you can help me.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...