Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CLI Help

Scenario: Cisco MDS9509 3 vsans (Prod, SRDF, Backup)

Question: I would like to set the Prod vsan as the principal switch

I have set static domain ids

prod = 1

srdf = 3

backup = 5

How would I do this?

Regards.

3 REPLIES
Bronze

Re: CLI Help

Howdy,

You need to set your switch priority. If you do not set the switch priority, the switch with the lowest wwn will be selected as the principal.

from the command line it is...

fcdomain priority [number]

Cheers

Andrew

Community Member

Re: CLI Help

Thanks Andrew.

Just to be clear:

conf t

fcdomain priority 1

exit

This would set the prod vsan i.e. fcdomain 1 to the principal switch?

Regards,

Bronze

Re: CLI Help

G'day,

The syntax is correct, however switch priority is not based per vsan.

It will cause the switch you are on to become the principal switch for all vsan's than are trunked.

Cheers

Andrew

154
Views
5
Helpful
3
Replies
CreatePlease to create content