Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Connect to ad MDS 9000 family

Can i connect to mds9000 family with putty an ethernet cable and the default ipv4 (if exists)?

2 REPLIES

Hi ,  Yes you can login .

Hi , 

 Yes you can login . 

Management Interface

 

The management interface allows multiple simultaneous Telnet or SNMP sessions. You can remotely configure the device through the management interface (mgmt0), but first you must configure some IP parameters so that the switch is reachable. You can manually configure the management interface from the CLI. You can configure the mgmt 0 interface with either IPv4 address parameters or an IPv6 address.

 

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/6_2/configuration/guides/fundamentals/b_Cisco_MDS_9000_Series_NX-OS_Fundamentals_Configuration_Guide_Release_6_x/b_Cisco_MDS_9000_Series_NX-OS_Fundamentals_Configuration_Guide_Releas...

 

HTH

Sandy

New Member

This discussion has been

This discussion has been reposted from Cisco User Groups to the Storage Networking community.

27
Views
0
Helpful
2
Replies