Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

creating san-port-channel on 6248 using CLI

I can create the san port channel using UCS manager. But I would like to know the syntax using CLI. So far I was able to figure out the following. One thing missing was moving the port channel from the default VSAN(1) to a different VSAN i.e VSAN 10 in my case. I have looked at the CLI guide, but have not found the commands syntax. Appreciate if anyone can post the syntax

 

### Create Port Channel ###
scope fc-uplink
scope fabric a
create port-channel 1
enable
set name port-channel-1
set adminspeed auto
commit-buffer
end
 
### Add interfaces to Port Channel ###
scope fc-uplink
scope fabric a
scope port-channel 1
create member-port 1 29
exit
create member-port 1 30
commit-buffer
end
Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Green

I would do reverse

I would do reverse Engineering

1) use UCS Manager to do it

2) check the result: ssh to FI, and do "show configuration"

I assume you are in FC EHM (NPV); therefore if you connect to a MDS/N5k, you should enable F-Port-Trunking-Channeling

Must look similar to

scope fabric a

         enter vsan 1234 1234 1234
             set fc-zoning disabled
             set fcoe-vlan 1234
             set id 1234
             enter member-port a 1 35
             exit
             enter member-port a 1 36
             exit
             enter member-port a 1 37
             exit
             enter member-port a 1 38
             exit
             enter member-port-channel a 111
             exit
             localize
         exit

 

2 REPLIES
VIP Green

I would do reverse

I would do reverse Engineering

1) use UCS Manager to do it

2) check the result: ssh to FI, and do "show configuration"

I assume you are in FC EHM (NPV); therefore if you connect to a MDS/N5k, you should enable F-Port-Trunking-Channeling

Must look similar to

scope fabric a

         enter vsan 1234 1234 1234
             set fc-zoning disabled
             set fcoe-vlan 1234
             set id 1234
             enter member-port a 1 35
             exit
             enter member-port a 1 36
             exit
             enter member-port a 1 37
             exit
             enter member-port a 1 38
             exit
             enter member-port-channel a 111
             exit
             localize
         exit

 

New Member

Thanx Wdey. That's exactly

Thanx Wdey. That's exactly what I was looking for. Here is the syntax which works for me.

 

scope fc-uplink
    scope fabric a
        create port-channel 1
        enable
        set name port-channel-1
        set adminspeed auto
    commit-buffer
end
 
scope fc-uplink
    scope fabric a
        enter port-channel 1
            enable
            enter member-port 1 29
            enable
            exit
            enter member-port 1 30
            enable
            exit
            set adminspeed auto
        exit
        enter vsan VSAN10 10 10
            set fc-zoning disabled
            set fcoe-vlan 10
            set id 10
            enter member-port-channel a 1
            exit
            localize
         exit
     end
commit-buffer
65
Views
0
Helpful
2
Replies