Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

device manager disable/enable different than shut no shut

due to a migration I've been doing a lot of port debugging recently. Just curious it seems like something gets cleared when I do disable , enable from device manager that does not happen when I do a int, shut no shut - am I dreaming this? 

1 REPLY
Cisco Employee

They are one in the same. 

They are one in the same.  Enable is "no shut" and disable is "shut".

Best regards,

Jim

41
Views
0
Helpful
1
Replies